CAMPAGNOLA T-REX, Use And Maintenance Manual

Page: 32 / 368

Page. 32
Use and maintenance manual – Translation of
original Instruction.: 01, Date 04/11/2021
3.5 Tool composition
3.6 Technical data
3.7 Safety devices
• ON/OFF button (10): Switches the tool on and off.
• Releasing switch (6): Engages itself automatically when releasing the operating lever (7) and prevents from any
accidental tool operation.
• Bar guard (15): Protects the cutting bar (2) during transport.
• Chain guard (13): Protects the operator against any kickback effect.
• Hand guard (8): Protects the operator’s hand against any contact with the chain (1), if this should break or get out
of the bar.
Pos. Denomination Function
1 Chain Cuts branches, trunks, etc
2 Bar Drives the cutting chain
3 Locking nut Locks the bar
4 Adjusting screw Regulates the chain tension
5 Front guard Protects the pinion and the bar chain
6 Releasing switch Allows to start the tool safely
7 Operating lever Is pressed to operate the tool
8 Hand guard Protects the operator’s hand from the risk of touching the chain
9 Battery connector Allows to connect the tool to the battery.
10 ON/OFF button Switches the tool on and off
11 Handle Allows to hold the tool
12 Plug with built-in rubber bulb Allows to manually lubricate the chain and closes the oil reservoir
13 Chain guard Protects the operator from any kickback
14 Lubricating oil reservoir Contains the oil for the bar and chain lubrication
15 Bar guard Protects the chain when the tool is not used
16 Battery Allows to operate the tool
17 Releasing plates Allow to insert the battery into the tool or to remove it
18 Battery charger Charges up to three batteries in sequence
19 LED light indicators Show the battery charge status
20 Recharge connectors Connect the battery charger to the battery
Dati tecnici
Bar length:
4”
4” bar maximum cut:
Ø 100 mm
Cutting chain:
29 teeth, 1/4”
Active safety device
YES
Variable speed
YES
Chain speed
8.5 m/sec
2.5 Ah battery cutting performance
Approx. 90 cuts of 8 cm Ø
4 Ah battery cutting performance
Approx. 150 cuts of 8 cm Ø
Battery rated/ max. voltage
21.6 V / 24 V
Li-Ion battery
2.5 Ah and 4 Ah
Charge voltage
AC110V-220V
Charge duration
1.5-3 h each battery
Tool weight w/o battery
1000 g
2.5 Ah battery weight
330 g
4 Ah battery weight
480 g
Total tool weight
1330 g / 1480 g