Use and Maintenance Manual – Original
Instructions Rev.: 02, Data 11/02/2021
Pag. 23
11
Telescopic extension pole
Holds the tool
C-D
12
Fixed extension pole
Holds the tool
C-D
13
Power supply cable connector
Connects the power unit with the power supply cable
C-E
14
13 m power supply cable
Connects the power unit with the lead battery
C-E
15
1.5 m power supply cable
Connects the power unit with the lithium battery
G
16
Speed selector led lights
Indicate the selected speed
B
3.6 Technical details
•
Power unit weight:
850 g
•
Motor rotation speed
I
:
1080 ± 20 rpm (1 red Led on)
•
Motor rotation speed
II
:
1150 ± 20 rpm (1 red Led on)
•
Motor rotation speed
III
:
1180 ± 20 rpm (2 red Led on)
3.7 Safety devices
•
Built-in safety device: stops the tool automatically in case of motor overheating.
•
ON/OFF Led light (9): indicates the tool is working.
•
Poles inversion protection in connection with the lead battery.
•
Min. and max. lithium battery voltage: 10V – 14V
3.8 Warning symbols
4 INSTALLATION
4.1 Start-up
•
Remove the power unit (1) and the cable (14-15) from their box.
•
Assemble the power unit onto the extension pole with the chosen harvesting head. Insert the shaft (10) and tighten the
screws (2) of the clamp connection (3).
•
Insert the power supply cable (14-15) into the handgrip hole.
•
Join the power supply cable (14-15) with the connector (4) taking care of the male and female connections. Use the
antierror device for the proper connectors insertion.
•
Start the tool by means of the ON/OFF switch (7) and check the led light (9) is on.
4.2 Selection and variation of the speed
On the ON/OFF switching sticker press the button (8) to select the motor speed: position
I
: 1080 rpm, position
II
: 1150
rpm, position
III
: 1180 rpm.
4.3 Procedure for setting/unsetting the power saver function
•
Connect the power unit to the battery
•
Do not start the tool, keep the speed selector (8) pressed for 5 sec., until the
ON
red led light (9) flashes confirming the
operation.
•
Start the tool with the power saver function inserted. The speed selector LED light (16) flashes.
•
To unset the power saver funcion, keep the speed selector (8) pressed for 5 sec,. until the
ON
red light (9) flashes,
confirming the operation.
General warning
Compulsory adequate clothing
Duty of reading the use
& maintenance manual
Compulsory hands protection
Compulsory head protection
Compulsory feet protection
