![background image](http://html.mh-extra.com/html/campagnola/holly/holly_use-and-maintenance-manual_488424021.webp)
Pag. 20
Use and maintenance manual – Translation of
original Instruction Rev.: 03, Date 10/09/2021
Troubleshooting
WARNING!
All the following special maintenance operations shall be carried out by a service mechanic.
FAULT
CAUSE
REMEDY
Mechanical head overheating. Dirt and/or wear and tear of the
inner rotating parts.
Carry out the mechanical head cleaning and
maintenance operations.
Anomalous rake (2) vibrations. • Rotating parts wear and tear.
• Wrong tightening of the rake
fixing screws (6).
• Carry out the mechanical head cleaning and
maintenance operations.
• Tighten the screws (6).
The tool does not work.
Flat battery.
Recharge the battery (read the power unit manual).
The tool is not powerful
enough.
Falt battery.
Recharge the battery (read the power unit manual).
Temporary tool stopping dur-
ing its use.
• Motor overheating due to
thick branches.
•
Exceeded current limits
Get out of the tree, wait for few seconds and then
start the tool again by means of the ON-OFF
switch (read the power unit manual).
IMPORTANT: If the above-mentioned remedies do not solve the problem, contact an Authorised Service Point
Improper uses
- Never use the tool when your balance is unstable.
- Never use the tool as a lever or for lifting, moving or breaking any objects.
- Never use the tool if the atmosphere is explosive or inflammable.
Tool transport
In case of long transports keep the tool in its packaging.
WARNING!
Use the tool only for the purposes described in par. “Product Description”. Any other use can cause injuries
and damages.
Routine maintenance
WARNING!
•
Before any routine maintenance operations, if the harvesting head is assembled on the tool, switch the
harvester off (read the power unit manual), disconnect the power supply cable and then remove the head
from the extension pole (11-12).
•
All maintenance operations which are not described in this manual shall be carried out only by an Authorised
Service Point.
Routine maintenance operations can be carried out by the operators.
General
Before any routine maintenance operation:
•
Select the OFF mode of the power unit switch.
•
Wear protective gloves.
•
Disconnect the harvesting head from the extension pole (11-12).
Replacing the teeth
The damaged teeth (1) have to be removed from their seat:
•
Disassemble the teeth holder (7) by removing the 4 screws (6).
•
Put the teeth holder (7) onto a surface and shorten the damaged teeth (1) 2 cm away from the holder.
•
By means of a rubber hammer hit the top of the tooth (1) till it gets out of its seat.
•
Put the new tooth (1) into its seat, being careful to hook the small plastic protrusion to the teeth holder (7) side.
•
Re-assemble the rake (2) onto the oscillator (8).
Cleaning and greasing the harvesting head
Every 200 work hours, open the mechanical head and remove any dust and dirt inside of it. Check the anti-rotation
drives (10) condition and add Campagnola LISYNT-00-EP spray grease.
Summary of Contents for HOLLY
Page 2: ...9 2 1 7 5 3 4 6 6 Fig A 8 10 11 12 ...
Page 3: ......