Actiwatch Guide to Getting Started 7.2 (July 2009)
When using the Actiwatch USB reader, it is not necessary to
manually set the communications port. Once the software has
been installed and the USB reader plugged in, the correct
communications port will be automatically set by the software.
To check or change the communications port manually,
selecting ‘Reader’ and then ‘Comms’ brings up the following
screen:
When an Actiwatch is detected via the USB reader, the
message shown above in red will change to a green message
stating that the Actiwatch has been detected and is ready. The
red ‘READY’ LED should be lit on the front panel of the reader.
Please note that the USB reader is only compatible with
Actiwatch software
version 7 or later
.
The various models of Actiwatch must be placed on the reader
as shown below:
2.9 Checking the USB
Reader Operation
2.10 Correct Placement of
Actiwatch Models on the
USB Reader
Actiwatch 7
Actiwatch 4, AWL etc.
Actiwatch Score, Alert etc.
Actiwatch Mini and Actilight
