EMC_SPEC018_C2.doc
Rev. D
–
2020 05 19
13/44
Install & Operating Manual
CamSafe
8
Mounting of Configurations
CamSafe is a modular system of ducted modules. Subject to order conditions and/or transport
limitations, housings/modules and/or collectors of a configuration may be shipped separately.
Airtight assembly is required.
Module mounting is described based on housings and collectors but principles and steps are valid for
connecting any modules inside a configuration.
8.1
General Assembly of Housings / Collectors
Set up the bottom collector (or lowest level module), ensure access from all sides.
Place gaskets on the flange, aligning flange and gasket holes.
Interlocking connectors (modular gaskets only) facilitate placement.
Repeat for each opening,
then place the first housing.
PLEASE NOTE:
Housing gaskets may be in a single piece or modular with interlocking connectors.
Modular gaskets are self-adhesive (repositionable) to avoid leaks through connector
distortion when placing the housings.
Place bolts with washers.
Tighten nuts, do not block yet
at this point.
13
M8
