CAMERA LINK VC Series, User Manual

Page: 85 / 109

VC-5MC-M/C110H User's Manual
Page 85 of 109
9.23 Field Upgrade
The camera provides a feature to upgrade the Firmware and FPGA logic through the Camera
Link interface without disassembling the camera in the field. Refer to
Appendix A
for more details
about how to upgrade.
9.24 User Set Control
You can save the current camera settings to the camera’s internal Flash memory. You can also
load the camera settings from the camera’s internal Flash memory. The camera provides two
setups to save and three setups to load settings.
The XML parameters related to User Set Control are as follows.
XML Parameters
Value Description
UserSetControl UserSetSelector Default
Selects the Factory Default settings.
UserSet1 Selects the UserSet1 settings.
UserSet2 Selects the UserSet2 settings.
UserSetLoad - Loads the User Set specified by User Set Selector
to the camera.
UserSetSave - Saves the current settings to the User Set specified
by User Set Selector.
The Default is a Factory Default Settings and
allowed to load only.
UserSetDefault Default Applies the Factory Default settings when reset.
UserSet1 Applies the UserSet1 when reset.
UserSet2 Applies the UserSet2 when reset.
Table 9-28 XML Parameters related to User Set Control