18
Settings
Display Reverse
= Flip Display
On
= Rotation of the display by 180° (e.g. overhead installation)
Off
= no rotation of the display
Display Backlight
= Display lighting
On
= permanently on
Off
= deactivation after approx. 1 minute of inactivity
DMX Fail
= Operation status with DMX
signal interruption
Hold
= last command is held
Blackout
= activates Blackout
Dimmer Curve
= Dimmer Curve
Linear
= The light intensity increases linearly with the DMX value
Exponential
= Adjustment of the light intensity is finer in the lower DMX value
range and coarser in the upper DMX value range
Logarithmic
= Adjustment of the light intensity is coarser in the lower DMX value
range and finer in the upper DMX value range
S-Curve
= Adjustment of the light intensity is finer in the lower and upper
DMX value ranges and coarser in the middle DMX value range
Dimmer Response
= Dimmer response
Led
= The spotlight responds abruptly to changes in the DMX value
Halogen
= The spot behaves in a manner similar to that of a halogen lamp
with gentle changes in brightness
Color Calibration
= Colour calibration
Red, Green,
Blue, White
= individual colour calibration. Cross-operating mode brightness
setting of 4 RGBW LED groups with values ranging from 000 to 255.
Autolock
= automatic locking of the
control elements
On
= automatic locking of the control elements after 1 minute of
inactivity. Display shows: "Locked!"
Unlock: simultaneously press UP and DOWN for about 5 seconds
Off
= automatic locking of the control elements is deactivated
IR Remote
= enable / disable operation via
IR remote control
On
= functionality enabled
Off
= functionality disabled
Factory Reset
= Reset to factory setting
Reset to factory settings: ENTER -> "Reset Now! -> ENTER
Confirm all inputs with ENTER.
DIMMER CURVES
Light intensity
Light intensity
Light intensity
Light intensity
DMX value
linear
exponential
logarithmic
S-curve
DMX value
DMX value
DMX value
SYSTEM INFORMATION (System Info)
Pressing MODE will take you to the selection menu for system settings (--- Menu ---). Using UP and DOWN, select the menu item “System Info”
(observe the arrow) and confirm with ENTER.
Menu
Mode
Settings
System Info
The required sub-menu can be selected as desired by using UP and DOWN in order to show the corresponding information by pressing ENTER.
System Info
Firmware
= Displays the Firmware version
Main CPU
Vx.x
Temperature
= Temperature display of the LED unit
LED
xx°C / xx°F
Unit
°C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
Operation Hours
= Operating time display
xx:xxh
Displays the operating time in hours and minutes
MANUAL LOCKING FUNCTION
In addition to the ability to protect the spotlight automatically against accidental or unauthorised operation (see “Settings” - “Autolock”), this function
can also be carried out manually. Press UP and DOWN simultaneously for approx. 5 seconds. The display now shows “Locked!” if you try to change
the settings, and it is no longer possible to make changes using the control panel. After approximately 1 minute, the display will show the currently
enabled operating mode. To unlock, press UP and DOWN simultaneously for approx. 5 seconds. Now the display will change to the previously
displayed information.
