ENGLISH
Page
31
- Manual code:
FA00464-EN
ver
.
1
03/2017 © C
AME S.p.a. - The data and information shown in this manual ar
e t
o be consider
ed as subject t
o change at any time and without the need for any advance warning.
Learning radio inputs
Learning radio inputs can be done during first switch-on of
the control unit, following the voice guide (see "SELF-LEARNING
MENU" section), or later via the Technical Menu, as described be-
low
STEP 1: Acquiring new radio input
1 Go into the Technical Menu
2 With
(▲)
/
(▼)
select
INPUTS
and press
(*)
3 With
(▲)
/
(▼)
select the radio input to be acquired and press
(*)
4 With
(▲)
/
(▼)
select
SELF-LEARN
and press
(*)
5 With the radio transmitter powered by the battery press the
self-learn button (see device manual)
6 The control unit stores the new radio device (if one had been
acquired previously, the new one overwrites the old one)
7 If it is a radio device with several channels, you have to define
the radio channel to associate with the input (for example, the
radio contact has 3 channels: input 1, input 2 and magnetic
contact) See the available channels in the device manual
*
*
*
INPUTS 11
MODIFY INPUT XXX
INPUT XXX
▼
▲
▼
▲
LEARN XXX
*=OK #=ESC
RADIO CHANNEL XXX
[1..03] NUMBER 03
▼
▲
PRESS LEARNING
BUTTON
OK PRESS *
Example:
• Installing a magnetic radio contact onto a window
• In sequence:
• Access: technical menu ->
INPUTS
• Select which radio input to acquire (the order is first the wired
inputs and then the radio inputs)
• Select heading
SELF-LEARN.
and press the self-learning button
of the magnetic contact to complete the acquisition If the re-
ceiver has already been acquired, pressing the key activates
verification of the intensity of the field (on the receiver's LED)
• If you wish to assign the magnetic contact's channel to the
radio input, select 3 (default) on
RADIO CHANNEL
• Proceed to set the following general input parameters
Programming Outputs
On leaving the factory the control unit's four outputs are set at:
INDEX NUMBER OUTPUT DESCRIPTION
U1
TC output to inhibit the sensors’
microwave when the system is off
(associated with the BEDROOM area)
Yields a positive with BEDROOM area off
U2
System status, yields a negative if at least one
area is on
U3
Failure, yields a negative when failures are
detected
U4
Technical, yields a negative when there is at
least one technical alarm
RELAY
Relay 1, is activated during the alarm time
If you need to change settings see the output's parameters in the
technical menu
Programming telephone calls and SMS
To set up the telephone calls, you have to:
•
Set call priority
•
Set the numbers to be called
•
Record the common message and then the one for areas
and inputs
SETTING PSTN - GSM PRIORITY
To set whether, in the event of voice calls, PSTN or GSM is to be
selected, you must:
1 Go into the Technical Menu
2 With
(
▲
)
/
(
▼
)
select
TELEPHONE OPTIONS
and press
(*)
3 With
(
▲
)
/
(
▼
)
select
LINE PRIORITY
4 With
(
+
)
/
(
‒
)
select
GSM
or
PSTN
to indicate the priority chosen
5 Press
(#)
to quit and go back to the previous menus
*
TELEPHONE 20
OPTIONS
LINE PRIORITY
PSTN
▼
▲
▼
▲
