A
ll t
h
e d
at
a a
n
d i
n
fo
rm
at
io
n c
o
n
ta
in
ed h
er
ei
n
i
s c
o
n
si
d
er
ed
s
u
b
je
ct to c
h
an
g
e a
t a
n
y t
im
e a
n
d a
t o
u
r d
is
cr
et
io
n
16
ENGLISH
5.9 Adjusting mechanical end-stops
Make sure the door is in a closed position
and the two crown wheels of the motor
units are both positioned to the left.
N.B.: the gearmotor is already adjusted
in a closed position, namely, the closing
end-stop micro-switch is activated.
Execute a complete opening run manually
or by using the button on the command
board; the two crowns will move to the
right.
Using a screwdriver, raise the end-stop
spring from the crown wheels; manually
move the white crown until it reaches the
opening microswitch and then lower the
spring onto the crowns.
Warning! After making the adjustments
on sectional doors in a closed position,
there may be a gap between the lower
edge of the door and the ground
surface. To eliminate this gap, move the
micrometric lever one step up or down to
lower or raise the door by one centimetre.
Make a complete closing run and ensure
that the release lever is free from the
safety lever.
NB: the safety lever releases the
emergency release (CMS or C002) only
when the door is closed.
Safety lever
Release lever
White opening crown
Red closing crown
Microswitch of end-stop in closing
Microswitch of end-stop in opening
End-stop spring
Micrometric lever
