7
- FA01922M4A
- 12/2022 © CAME S.p.A.
Dismantling and disposal
Dispose of the packaging and the device responsibly at the end of its life cycle, in compliance with
the laws in force in the country where the product is used. The recyclable components are marked
with the material symbol and ID.
THE DATA AND INFORMATION IN THIS MANUAL MAY BE CHANGED AT ANY TIME AND WITHOUT
NOTICE.
MEASUREMENTS ARE IN MILLIMETRES, UNLESS STATED OTHERWISE.
Description
806SL-0330
SELM2BDG - Recessed BUS transponder selector for MIFARE keycards with blue backlighting.
Grey colour RAL7024.
The device is compatible with CAME MIFARE keycards and MIFARE keycards. The
device is not compatible with keycards that use RFID 125 KHz technology.
Technical data
MODELS
SELM2BDG
BUS connection (CXN Unit)
3
Power (W)
0.97
Absorbed current (mA)
65
Operating temperature (°C)
-20 ÷ +55
Storage temperature (°C)*
-25 ÷ +70
Protection rating (IP)
54
Insulation class
III
Average life (cycles)**
500000
(*) Before installing the product, keep it at room temperature where it has previously been
stored or transported at a very high or very low temperature.
(**) The average product life is a purely indicative estimate. It applies to compliant usage,
installation and maintenance conditions. It is also infl uenced by other factors, such as climatic
and environmental conditions.
Description of parts
A
1
Front cover
2
Transponder
3
Board protection cover
4
Rubber gasket
5
Front frame
6
Recessed gasket
7
Recessed casing
Control board
B
8
Set-up DIP switch
9
Terminal block
10
Status warning LED
Size
C
Installation
D
Connections and settings
E
For systems with more than one selector, please check the control panel or operator
manual for information on the diff erent types of wiring.
BUS configuration
We recommend using a FROR 2x1mm² cable, maximum length from the control board:
50 m.
Do not use a shielded cable.
Connect the selector to the BUS terminal on the control panel.
Up to 7 BUS selectors can be connected (keypad, transponder, Bluetooth or key).
If there are multiple BUS selectors connected in the system, set a diff erent address for each
selector using DIPs 1 2 3.
If two selectors have the same address on the BUS, the backlighting fl ashes red to
highlight the confi guration error.
