Notifications
PTP 450 Configuration and User
pmp-0815 (August 2015)
6-43
Notifications
This section contains notifications of compliance with the radio regulations that are
enforced in various regions.
PTP 450 regulatory compliance
The PTP 450 complies with the regulations that are enforced in the USA and Canada.
The relevant notifications are specified in this section.
PTP 450 FCC and IC notification
U.S. Federal Communication Commission (FCC) and Industry Canada (IC) Notification.
This system has achieved Type Approval in various countries around the world. This
means that the system has been tested against various local technical regulations and
found to comply. The frequency band in which the system operates is ‘license exempt’
and the system is allowed to be used provided it does not cause interference. The
licensing authority does not guarantee protection against interference from other
products and installations.
This device complies with part 15 of the US FCC Rules and Regulations and with RSS-
210 of Industry Canada. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation. In
Canada, users must be cautioned to take note that high power radars are allocated as
primary users (meaning they have priority) of the 5650 – 5850 MHz spectrum and these
radars could cause interference and/or damage to license-exempt local area networks
(LELAN).
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna type
and its gain must be so chosen that the equivalent isotropically radiated power (EIRP) is
not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et
son gain de sorte que la puissance isotrope rayonnée équivalente (PIRE) ne dépasse pas
l'intensité nécessaire à l'établissement d'une communication satisfaisante.
