Chapter 15: Ethernet Services and Interfaces (CLI)
Configuring Ethernet Interfaces (CLI)
phn-3963_008v000
Page 15-31
The QSFP port (Port 4), is displayed as follows.
•
In a 4x1/10G configuration the QSFP port can provide four Ethernet interfaces: Eth3, Eth4, Eth 5, and Eth6. In
this configuration, a QSFP transceiver is attached to the QSFP port, and an MPO-MPO cable is connected
between the transceiver and a splitter on the other side of the link. The splitter splits the traffic between four
Ethernet cables connecting the splitter to the customer equipment.
The following command enters interface view for Ethernet 7:
root> ethernet interfaces eth slot 1 port 7
The following prompt appears:
eth type eth [1/7]>
The following command enters interface view for the radio interface:
root> ethernet interfaces radio slot 1 port 1
The following prompt appears:
radio [1/1]>
Note
For simplicity, the examples in the following sections show the prompt for an Ethernet interface.
Displaying the Operational State of the Interfaces in the Unit
(CLI)
To display a list of all interfaces in the unit and their operational states, enter the following command:
root> platform if-manager show interfaces
The following is a sample output of this command:
Viewing Interface Attributes (CLI)
To display an interface’s attributes, go to interface view for the interface and enter the following command:
eth type eth [1/x]>summary show