Chapter 5: Radio Configuration
Configuring and Viewing Radio PMs and Statistics
phn-3963_008v000
Page 5-7
You can also display the current BER level.
To configure the BER thresholds and Excessive BER Administration, and display current BER levels
1.
Select
Radio > Radio BER Thresholds
. The Radio BER Thresholds page opens. The current BER level is
displayed, per radio, in the Radio BER column.
Figure 60
Radio BER Thresholds Page
2.
In the
Excessive BER admin
field, select
Enable
to enable excessive BER administration or
Disable
to disable
excessive BER administration. Excessive BER administration determines whether or not excessive BER is
propagated as a fault and considered a system event. For example, if excessive BER administration is enabled,
excessive BER can trigger a protection switchover and can cause a synchronization source to go into a failure
status. Excessive BER administration is enabled or disabled for the entire unit rather than for specific radios.
3.
In the
Excessive BER Threshold field
, select the level above which an excessive BER alarm is issued for errors
detected over the radio link.
4.
In the
Signal Degrade BER Threshold
field, select the level above which a Signal Degrade alarm is issued for
errors detected over the radio link.
5.
Click
Apply
, then
Close
.
Displaying MRMC Status
Related Topics
:
•
Configuring the Radio (MRMC) Script(s)
To display the current modulation and bit rate per radio:
1.
Select
Radio > MRMC > MRMC Status
. The MRMC Status page opens.
Figure 61
MRMC Status Page