Chapter 5: Generic Installation Procedures and Notes
Torque Requirements
phn-4794_002v000
Page 5-2
General Notes Concerning All Installation Procedures
Some of the configurations described in this manual may not be supported with every Cambium version.
For up-to-date information about which configurations are supported, refer to the Release Notes for the
Cambium version you are using.
Note that 4 and 5 GHz links are currently supported only with diplexer-based branching and remote-
mount configurations.
Since the PTP 820C HP architecture is of a Dual Core nature, each dual core configuration can be
considered as single core configuration hardware ready for its dual core counterpart. Therefore, you
should follow the same procedure for 2+0 SP installation, if you want to install a 1+0 SP HW ready
for
2+0
SP.
One of the major benefits of the PTP 820C HP and the dual core architecture is that upgrading can be
done remotely by uploading the correct software license.
Before starting an installation, use a leveler to make sure that the poles are 100% vertical. You need to
check both sides of each pole at 90 degrees separation. This is a critical step in any link but most important
when installing MIMO or XPIC.
Note
Do not remove the transparent pressure windows located on the antenna interfaces.
Figure 23 Transparent Pressure Windows
