Chapter 21: TDM Services and Interfaces (CLI)
Configuring TDM Pseudowire Services (CLI)
phn-3965_006v002
Page 21-22
Note
Since the edge node itself is part of the protected or protecting path, the node itself is essentially
unprotected and you do not need to configure a tunnel group for the node.
Table 288
Network Edge Node for Dual Homing CLI Parameters
Parameter
Input Type
Permitted Values
Description
slot
Number
1
tunnel
Number
Any configured TDM
tunnel ID.
The ID of the TDM tunnel.
Manually Configuring Pseudowire Services (CLI)
Note
It is recommended to use the Web EMS TDM Pseudowire Services interface, which provides a step-
by-step workflow based on pre-configured pseudowire settings. See
For PTP 820F and PTP 820G, you can configure up to 16 TDM pseudowire services. Pseudowire service
configuration must be performed from pwe3 view:
root> pwe3
pwe3>
Caution
Once a profile, tunnel, or bundle has been assigned to a service, you cannot modify that profile,
tunnel, or bundle until you first disable the service.
To configure and enable a pseudowire service, use the following commands:
pwe3> pwe3 pws satop-eth add slot <slot> id <id> tdm-port <tdm-port> pw-
profile-id <pw-profile-id> psn-tunnel-id <psn-tunnel-id> src-ecid <src-
ecid> dst-ecid <dst-ecid> cr-master-pws <cr-master-pws> protected
<protected>
pwe3> pwe3 pws enable slot <slot> id <id>
To display the status of all pseudowire services, enter the following command in pwe3 view:
pwe3> pwe3 pws status show slot <slot>
The following is an example of a pwe3 pws status show slot command and its output:
Summary of Contents for PTP 820 Series
