Cambium Networks PTP 820 Series, User Manual

Page: 943 / 1149

Chapter 20: Ethernet Protocols (CLI) Configuring MSTP (CLI)
phn-3965_006v002
Page 20-20
Setting and Viewing the Bridge Level MSTI Parameters (CLI)
To set the bridge priority for an MSTI, enter the following command in root view:
root> ethernet mstp set instance <msti-id> msti-bridge-priority <msti-
bridge-priority>
To display the bridge parameters of an MSTI, enter the following command in root view:
root> ethernet mstp show-msti-attributes instance <msti-id>
Table 271 Bridge Level MSTI CLI Parameters
Parameter Input Type Permitted Values Description
instance Number 1-16 Enter the MSTI ID of the MSTI you want to
configure.
msti-bridge-
priority Number 0-61440, in steps of
4096. The MSTI writeable portion of the Bridge ID.
interface Variable eth
radio
pwe Enter the type of interface:
eth – Ethernet
radio
– Radio
pwe – TDM
slot Number 1
port Number ethernet: 1-6
radio: 1-2
management: 1-2
tdm: 1 The interface you want to configure.
group Variable rp1
rp2
rp3
rp4
lag1
lag2
lag3
lag4
mc-abc1
mc-abc2
mc-abc3
mc-abc4 To display bridge parameters for a 1+1 HSB
group, a LAG group, or a Multi-Carrier ABC
group, use this parameter instead of the
interface, slot, and port parameters to
identify the group. See:
•
Configuring HSB Radio Protection (CLI)
•
Configuring Link Aggregation (LAG) and
LACP
(CLI)
•
Configuring Multi-Carrier ABC (CLI)
The following command sets the bridge priority for MSTI 15 to 28672:
root> ethernet mstp set instance 15 msti-bridge-priority 28672