Cambium Networks PTP 820 Series, User Manual, Page: 928 / 1149

Chapter 20: Ethernet Protocols (CLI) Configuring G.8032 (CLI)
phn-3965_006v002
Page 20-5
Parameter Input Type Permitted Values Description
erpi-id Number 1-64 The ID of the ERPI for which you want to set
or delete the RPL owner.
SP Number or
Variable east
west
sub-ring Specifies the service point you want to
designate as the RPL owner.
The following command sets the East service point as the RPL owner for ERPI 1:
root> ethernet g8032 set-rpl-owner erpi-id 1 SP east
The following command sets the Sub-Ring service point as the RPL owner for ERPI 20:
root> ethernet g8032 set-rpl-owner erpi-id 20 SP sub-ring
The following command removes the RPL owner for ERPI 1:
root> ethernet g8032 remove-rpl-owner erpi-id 1
Configuring Timers (CLI)
You can configure timers per ERPI to control the ERPI's switching and convergence parameters. The following
timers are available:
•
Wait to Restore (WTR) Timer – Defines a minimum time the system waits after signal failure is recovered
before reverting to idle state.
•
Guard Time – Prevents unnecessary state changes and loops.
•
Hold-Off Time – Determines the time period from failure detection to response.
To configure the WTR timer, enter the following command in root view:
root> ethernet g8032 set-wtr erpi-id <erpi-id> wtr <wtr>
To configure the guard time, enter the following command in root view:
root> ethernet g8032 set-guard-time erpi-id <erpi-id> guard-time <guard-
time>
To configure the hold-off, enter the following command in root view:
root> ethernet g8032 set-holdoff-time erpi-id <erpi-id> holdoff-time
<holdoff-time>
Table 259 G.8032 Timer Configuration CLI Parameters
Parameter Input Type Permitted Values Description
erpi-id Number 1-64 The ID of the ERPI for which you want to set
a timer.
wtr Number 1-12 The minimum time (in minutes) the system
waits after signal failure is recovered before
reverting to idle state.