Cambium Networks PTP 820 Series, User Manual, Page: 892 / 1149

Chapter 19: Quality of Service (QoS) (CLI) Configuring Marking (CLI)
phn-3965_006v002
Page 19-25
Parameter Input Type Permitted Values Description
sp-id Number 1-32 for P2P and MP
services.
1-30 for MNG
services. The Service Point ID.
mode Variable enable
disable Determines whether re-marking of the
outer VLAN (C-VLAN or S-VLAN) of tagged
frames that pass through the service point
is enabled.
If
mode
is set to
enable
, and CoS
preservation for the relevant outer VLAN
is set to
disable
, the service point re-
marks the C-VLAN or S-VLAN 802.1p UP
bits of egress frames according to the
calculated CoS and Color, and the user-
configurable 802.1Q and 802.1AD marking
tables.
If mode is set to enable and CoS
preservation for the relevant outer VLAN
is also set to
enable , re-marking is not
performed.
If
mode
is set to
disable
and CoS
preservation for the relevant outer VLAN
is also set to
disable
, re-marking is
applied, but only according to the values
defined for Green frames in the 802.1Q
and 802.1AD marking tables.
For information about configuring CoS
Preservation, refer to CoS Preservation
and Modification on a Service Point.
The following command enables marking mode on Service Point 3 on Service 2:
service[2]>sp marking set spid 3 mode enable
The following command disables marking mode on Service Point 3 on Service 2:
service[2]>sp marking set spid 3 mode disable
Marking Table for C-VLAN UP Bits (CLI)
When marking is performed, the following table is used by the marker to decide which CoS and Color to use as the
egress CoS and Color bits for C-VLAN-tagged frames.
Table 235 Marking Table for C-VLAN UP Bits