Cambium Networks PTP 820 Series, User Manual, Page: 883 / 1149

Chapter 19: Quality of Service (QoS) (CLI) Configuring Policers (Rate Metering) (CLI)
phn-3965_006v002
Page 19-16
•
CBS – 5 Kbytes
•
EIR – 64,000 bps
•
EBS – 5 Kbytes
•
Color Blind mode
•
Coupling Flag disabled
The following command edits the rate meter (policer) profile with Profile ID 50, and changes its name to
“256 kB ytes.”
root> ethernet qos rate-meter edit profile-id 50 cir 128000 cbs 5 eir
128000 ebs 5 color-mode color-aware coupling-flag enable rate-meter-
profile-name 256 kBytes
This edited profile includes the following parameters:
•
CIR – 128,000 bps
•
CBS – 5 Kbytes
•
EIR – 128,000 bps
•
EBS – 5 Kbytes
•
Color Aware mode
•
Coupling Flag enabled
Displaying Rate Meter Profiles (CLI)
You can display all configured rate meter (policer) profiles or a specific profile.
To display a specific profile, enter the following command:
root> ethernet qos rate-meter show profile-id <profile-id>
For example, the following command displays the parameters of Rate Meter Profile 50:
root> ethernet qos rate-meter show profile-id 50
To display all configured profiles, enter the following command:
root> ethernet qos rate-meter show profile-id all
Deleting a Rate Meter Profile (CLI)
You cannot delete a rate meter (policer) profile that is attached to a logical interface. You must first remove the
profile from the logical interface, then delete the profile.
To delete a rate meter (policer) profile, use the following command:
root> ethernet qos rate-meter delete profile-id <profile-id>
The following command deletes Rate Meter Profile 50:
root> ethernet qos rate-meter delete profile-id 50
Attaching a Rate Meter (Policer) to an Interface (CLI)
On the logical interface level, you can assign rate meter (policer) profiles as follows: