Cambium Networks PTP 820 Series, User Manual

Page: 856 / 1149

Chapter 18: Ethernet Services and Interfaces (CLI) Configuring Ethernet Interfaces (CLI)
phn-3965_006v002
Page 18-37
Table 205 Interface Speed and Duplex State CLI Parameters
Parameter Input Type Permitted Values Description
speed-and-
duplex state Variable '10hd'
'10fd'
'100hd'
'100fd'
'1000fd'
This parameter sets the maximum speed
and the duplex state of the interface. For
RJ-45 interfaces, any of the permitted
values can be configured. For SFP
interfaces, only '1000fd' is supported.
Note
10HD is not supported in the current release.
The following command sets GbE 1 to 100 Mbps, full duplex:
eth type eth [1/1]>speed-and-duplex state set '100fd'
Note
Before performing this command, you must verify that the media-type attribute is set to rj45.
The following command sets GbE 1 to 1000 Mbps, full duplex:
eth type eth [1/1]>speed-and-duplex state set '1000fd'
Configuring an Interface’s Auto Negotiation State (CLI)
To configure an Ethernet interface’s auto -negotiation state, go to interface view for the interface and enter the
following command:
eth type eth [x/x]>autoneg state set <autoneg state>
Table 206 Interface Auto Negotiation State CLI Parameters
Parameter Input Type Permitted Values Description
autoneg state Variable On
off
Enables or disables auto-negotiation on
the physical interface.
The following command enables auto negotiation for Ethernet port 4:
eth type eth [1/4]>autoneg state set on