Cambium Networks PTP 820 Series, User Manual, Page: 814 / 1149

Chapter 17: Radio Configuration (CLI) Configuring and Viewing Radio PMs and Statistics (CLI)
phn-3965_006v002
Page 17-25
radio [x/x]>modem signal-degrade set threshold 1e-7
To display the Signal Degrade BER threshold, go to radio view and enter the following command:
radio [x/x]>modem signal-degrade show threshold
Table 169 Signal Level Threshold CLI Parameters
Parameter Input Type Permitted Values Description
threshold Variable 1e -6
1e -7
1e -8
1e -9
1e -10
The BER level above which a Signal Degrade
alarm is issued for errors detected over the
radio link.
The following command sets the Signal Degrade threshold at 1e-7:
radio [2/1]>modem signal-degrade set threshold 1e-7
Configuring the MSE Thresholds and Displaying the MSE PMs
(CLI)
To configure the MSE (Mean Square Error) threshold, go to radio view and enter the following command:
radio [x/x]>modem set mse-exceed threshold <threshold>
To display the currently configured MSE threshold, go to radio view and enter the following command:
radio [x/x]>modem show threshold-mse-exceed
Table 170 MSE CLI Parameters
Parameter Input Type Permitted Values Description
threshold Number -99 - -1 The MSE threshold.
The following command sets the MSE threshold for radio interface 1 to -30:
radio[1/1]>modem set mse-exceed threshold -30
To display MSE (Mean Square Error) PMs in 15-minute intervals, go to radio view and enter the following
command:
radio [x/x]>modem pm-mse show interval 15min
The following is a partial sample output of the
modem pm-mse show interval 15min
command: