Cambium Networks PTP 820 Series, User Manual, Page: 689 / 1149

Chapter 12: Alarm Management and Troubleshooting Performing Diagnostics
phn-3965_006v002
Page 12-39
Configuring MIPs with MHF Default
If you configure a MEG with the MHF default option, MIPS are created automatically on all service points of the
service to which the MEG is attached. These MIPs cannot be displayed in the Web EMS, but can be displayed via
CLI. See
Displaying MEP and Remote MEP Attributes (CLI) .
Creating MIPs is subject to the following limitations:
•
Once you have created a MEG that contains MIPS, i.e., a MEG with the MHF default attribute, you cannot
create a MEG with the MHF none attribute on the same or higher level on the same Ethernet Service.
However, you can create MEGs with the MHF none attribute on the same service on lower levels then the
MEG with the MHF default attribute.
•
MEPs cannot be attached to a MEG with the MHF default attribute.
•
The Ethernet service and service points must already be defined before creating the MEG with the MHF
default attribute in order for MIPs to be created on the service points.
To configure MEGs with MIPs:
1 Create a MEG with the MHF none attribute on the intended Ethernet service. See Configuring MA/MEGs .
2 Select the MEG and click Edit . The SOAM MA/MEG – Edit page opens.
3 In the MIP Creation field, select MHF Default .
4 Click Apply , then Close .
Performing Loopback
To perform loopback on a MEP:
1 In the SOAM MEP page ( Figure 417 ), select the MEP on which you want to perform the loopback.
2 Click Loopback . The SOAM MEP – Loopback page opens.