Cambium Networks PTP 820 Series, User Manual, Page: 682 / 1149

Chapter 12: Alarm Management and Troubleshooting Performing Diagnostics
phn-3965_006v002
Page 12-32
4. Click Apply , then Close .
e. Configuring the Local MEPs
Once you have added local and remote MEPs, you must define the MEPs and determine which are the local MEPs:
1. Select Ethernet > Protocols > SOAM > MEP . The SOAM MEP page opens. Table 125 lists and describes the
parameters displayed in the SOAM MEP page.
Figure 417 SOAM MEP Page
Note
To display MEPs belonging to a specific MEG, select the MEG in the Filter by MA/MEG field near the
top of the SOAM MEP page. To display all MEPs configured for the unit, select All .
2. Click Add . Page 1 of the Add SOAM MEP wizard opens.
Figure 418 Add SOAM MEP Wizard – Page 1
3. In the MEG Name field, select an MA/MEG.
4. Click Next . Page 2 of the Add SOAM MEP wizard opens.