
Chapter 12: Alarm Management and Troubleshooting
Performing Diagnostics
phn-3965_006v002
Page 12-30
Parameter
Definition
MIP Creation
Determines whether MIPs are created on the MEG. Options are:
•
MHF none
–
No MIPs are created.
•
MHF default
–
MIPs are created automatically on any service point in
the MEG’s Ethernet service.
•
MHF explicit
–
MIPs are created on the service points of the MEG
when a lower-level MEP exists on the service point. This option is
usually used when the operator’s domain is
encompassed by another
domain.
•
MHF defer
–
No MIPs are created. Not used in the current release.
Table 124
SOAM MA/MEG Status Parameters
Parameter
Definition
MA/MEG ID
Automatically generated by the system.
MA/MEG Name Format
Reserved for future use. In the current release, this is Char String only.
Tx Sender ID TLV content
Sender ID TLV is transmitted.
Port Status TLV TX
Reserved for future use. No Port Status TLV is transmitted in the CCM
frame.
Interface Status TLV TX
An Interface Status TLV is transmitted in the CCM frame, indicating the
operational status of the interface on which the transmitting MEP is
configured (Up or Down)..
MEP List
Lists all local and remote MEPs that have been defined for the MEG.
Configuring MEPs
Each MEP is attached to a service point in an Ethernet service. The service and service point must be configured
before you configure the MEP. See
Configuring Ethernet Service(s)
Each MEP inherits the same VLAN, C-VLAN, or S-VLAN configuration as the service point on which it resides. See
In order to set the VLAN used by CCM/LBM/LTM if the service point is defined ambiguously (for example PIPE,
Bundle-C, Bundle-S, or All-to-
One), the service point’s C
-VLAN/S-VLAN parameter should
not
be set to N.A.
To configure a MEP, you must:
1.
Add MEPs to the relevant MA/MEG. In this stage, you add both local and remote MEPs. The only thing you
define at this point is the MEP ID. See
2.
Configure the local MEPs. At this point, you determine which MEPs are local MEPs. The system
automatically defines the other MEPs you configured in the previous step as remote MEPs. See
3.
Summary of Contents for PTP 820 Series
