Cambium Networks PTP 820 Series, User Manual, Page: 664 / 1149

Chapter 12: Alarm Management and Troubleshooting Configuring External Alarms
phn-3965_006v002
Page 12-14
In addition to adding the ability to configure these alarm thresholds, Release 10.9 adds PMs that indicate, per 15-
minute and 24-hour periods:
•
The number of seconds the unit was in an undervoltage state during the measured period.
•
The number of seconds the unit was in an overvoltage state during the measured period.
•
The lowest voltage during the measured period.
•
The highest voltage during the measured period.
These PMs are displayed via CLI. For instructions, see Configuring Voltage Alarm Thresholds and Displaying Voltage
Threshold PMs (CLI) .
Configuring the Output Alarm
To enable and configure the output alarm:
1 Select Platform > Management > External Alarms > Output . The External Alarms Output page opens.
Figure External Alarms Output Page
2 In the Admin field, select enable to enable the output alarm or disable to disable the output alarm.
3 In the Group field, select from a list of alarm groups, or select all groups . When an alarm belonging to the
selected group is raised, the alarm output is triggered. The available alarm groups are:
o
Communications
o
Quality of Service
o
Processing
o
Equipment