Cambium Networks PTP 820 Series, User Manual, Page: 547 / 1149

Chapter 9: TDM Services and Interfaces Configuring TDM Pseudowire Services
phn-3965_006v002
Page 9-39
Adding a Service between Radio Ports, Radio Groups, or Ethernet or
Cascading Interfaces
1 In the Interface #1 screen of the TDM PseudoWire Services Creation page, configure the parameters of the
service’s first endpoint.
Figure 316 Pseudowire Service Creation – Interface #1 (Radio/Ethernet/Cascading)
2 In the Slot/Group/Port field, select a radio interface, Radio Protection group, Multi-Carrier ABC group, or
cascading interface.
Note
Some interfaces may not appear in the Slot/Group/Port field. Refer to Limitations on Available
Endpoints for the possible reasons an interface will not appear. If there are no available interfaces, a
message appears that no endpoint can be selected.
3 In the VLAN Type field, select the VLAN Type for the first endpoint. The VLAN Type determines which
frames enter the service via this endpoint, based on the frame's VLAN tagging. Options are:
o
S-TAG – A single S- VLAN is classified to the service point.
o
C-TAG – - A single C- VLAN is classified to the service point.
4 In the S-VLAN or C-VLAN field, select the VLAN you want to classify to the endpoint (1-4090).
5 Click Next . The Interface #2 page opens. In the Interface #2, configure the parameters of the service’s
second endpoint.