Cambium Networks PTP 820 Series, User Manual, Page: 539 / 1149

Chapter 9: TDM Services and Interfaces Configuring TDM Pseudowire Services
phn-3965_006v002
Page 9-31
Configuring the Revertive Timer
1:1 pseudowire path protection can be configured to operate in revertive mode. In revertive mode, the system
monitors the availability of the protected path at all times. After switchover to the protecting path, once the
protected path is operational and available without any alarms, the system waits for the duration of the user-
configured Wait to Restore (WTR) time and then, if the protected path remains operational and available, initiates
a revertive protection switch. A single WTR time is configured for all the pseudowire services in the system.
However, services with 1:1 path protection can be configured individually as revertive or non-revertive.
Note
Pseudowire services with 1:1 path protection that were configured using software versions prior to
T7.9 are non-revertive.
To set the WTR time for services with revertive 1:1 path protection:
1 Underneath the TDM PseudoWire Services table, click Timer Configuration . The TDM Service Revertive
Timer Configuration page opens.
Figure 309 TDM Service Revertive Timer Configuration Page
2 Enter the number, in seconds, for the WTR time. The default value is 10 seconds.
3 Click Apply , then Close .
Adding TDM Pseudowire Services
To initiate the workflow for adding a pseudowire service:
1 Select TDM > TDM PseudoWire > Services . The TDM PseudoWire Services page opens (Figure 308 ).
2 Click Create Service . The Add Pseudowire TDM Service workflow begins. The workflow and options
provided by the TDM PseudoWire Services Creation page depends on the selection you make in the
Slot/Group/Port field. For detailed instructions per service type, see:
o
Adding a Service between a TDM Port or Protection Group and a Radio Port, a Radio Group, or an
Ethernet or Cascading Interface
o
Adding a Service between Radio Ports, Radio Groups, or Ethernet or Cascading Interfaces
You cannot add a pseudowire service if any of the following conditions exist:
•
There are no available pseudowire services.
o
There are no available Service IDs in the range reserved for TDM services (801-928), or