Cambium Networks PTP 820 Series, User Manual, Page: 493 / 1149

Chapter 8: Ethernet Protocols Configuring LLDP
phn-3965_006v002
Page 8-38
2. Modify the configurable parameters, described in Table 87 .
3. Click Apply .
Table 86 lists and describes the status parameters in the LLDP Configuration Parameters page.
Table 86 LLDP Read-Only Configuration Parameters
Parameter Definition
Max TX Credit Displays the maximum number of consecutive LLDPDUs that can be
transmitted at any one time. In this release, the Max TX Credit is set at 5.
Fast TX Interval (Seconds) Displays, in seconds, the interval at which LLDP frames are transmitted
during fast transmission periods, such as when the unit detects a new
peer. In this release, the Fast TX Interval is set at 1.
Fast TX The initial value used to initialize the variable which determines the
number of transmissions that are made during fast transmission periods.
In this release, the Fast TX No. is set at 4.
Reinit Delay (Seconds) Defines the minimum time, in seconds, the system waits after the LLDP
Admin status becomes Disabled until it will process a request to
reinitialize LLDP. For instructions on disabling or enabling LLDP on a port,
see
Configuring the LLDP Port Parameters .
In this release, the Reinit Delay is set at 2.