Chapter 6: Ethernet Services and Interfaces
Setting the MRU Size and the S-VLAN Ethertype
phn-3965_006v002
Page 6-22
Setting the MRU Size and the S-VLAN Ethertype
To configure the size of the MRU (Maximum Receive Unit) and the S-VLAN Ethertype:
1.
Select
Ethernet > General Configuration
. The Ethernet General Configuration page opens.
Figure 198
Ethernet General Configuration Page
2.
In the
MRU
field, enter the global size (in bytes) of the Maximum Receive Unit (MRU). Permitted values are
64 to 9612. The default value is 2000. Frames that are larger than the global MRU will be discarded.
3.
In the
S VLAN Ether type
field, select the S-VLAN Ethertype. This defines the ethertype recognized by the
system as the S-VLAN ethertype. Options are: 0x8100, 0x88A8, 0x9100, and 0x9200. The default value is
0x88A8.
Note
The C-VLAN Ethertype is set at 0x8100 and cannot be modified.
4.
Click
Apply
.
Summary of Contents for PTP 820 Series
