Cambium Networks PTP 820 Series, User Manual, Page: 325 / 1149

Chapter 5: Radio Configuration Configuring the Remote Radio Parameters
phn-3965_006v002
Page 5-11
3. Configure the remote radio parameters. For a description of these parameters, see Table 45 Remote Radio
Parameters .
4. Click Apply .
Figure 159 : Remote Radio Parameters Page Per Carrier – PTP 820G
You can also reset the remote radio or the entire remote unit from the Remote Radio Parameters – Edit page:
•
To reset the remote radio, click Reset remote Slot .
•
To reset the entire remote unit, click Reset Remote Unit .
. Table 45 Remote Radio Parameters
Parameter Definition
Radio Location Identifies the radio interface (Slot 1, port 1 or Slot 1, port 2).
Remote Radio Location Read-only. Identifies the location of the remote radio.
Local Remote Channel
Operational Status Read-only. The operational status of the active (in a protection
configuration) remote channel.
Remote Receiver Signal
Level Read-only. The Rx level of the remote radio, in dBm.