Chapter 3: Configuration Guide
Configuring Link Aggregation (LAG) and LACP
phn-3965_006v002
Page 3-90
Deleting a LAG Group
In order to delete a LAG group, you must first make sure that no service points are attached to the LAG group.
To delete a LAG group:
1.
Select
Ethernet > Interfaces > Groups > LAG
. The LAG page opens.
2.
Select the LAG group you want to delete in the Link Aggregation table.
3.
Click
Delete
underneath the Link Aggregation table. The LAG group is deleted.
To delete multiple LAG groups:
1.
Select the LAG groups in the Link Aggregation table or select all the LAG groups by selecting the check box in
the top row.
2.
Click
Delete
underneath the Link Aggregation table.
Displaying LACP Parameters and Statistics
You can display the following LACP parameters and statistics:
•
LACP Aggregation (per LAG)
•
LACP Port Status
•
LACP Port Statistics
•
LACP Port Debug Statistics
Note
PTP 820 does not support any LACP write parameters.
Displaying LACP Aggregation Status Parameters
To display LACP aggregation status parameters:
1. Select
Ethernet > Protocols > LACP > Aggregation
to open the LACP Aggregation page.
Summary of Contents for PTP 820 Series
