Cambium Networks PTP 820 Series, User Manual, Page: 247 / 1149

Chapter 3: Configuration Guide Configuring Link Aggregation (LAG) and LACP
phn-3965_006v002
Page 3-89
Configuring Enhanced LAG Distribution
You can change the distribution function by selecting from ten pre-defined LAG distribution schemes. The feature
includes a display of the TX throughput for each interface in the LAG, to help you identify the best LAG distribution
scheme for the specific link.
Note
Enhanced LAG distribution is only available for LAG groups that consist of exactly two interfaces. It
cannot be used with LACP.
To configure enhanced LAG distribution:
1. Select Ethernet > Interfaces > Groups > LAG . The LAG page opens ( Figure 101 ).
2. Click LAG DF underneath the Link Aggregation table. The LAG Distribution Function (DF) page opens.
Figure 103 LAG Distribution Function (DF) Page
3. In the Distribution Function field, select a pre-set distribution scheme, from 1 to 10. It is recommended to
experiment with the various schemes, monitoring the TX byte count fields for each interface to determine
the efficiency of each distribution scheme for the link. The default distribution scheme is 1.
4. To clear the TX byte counts, select Clear on read for one or both interfaces. The byte counts will be
cleared when you close the LAG Distribution Function (DF) page or click Refresh .
Note
This counter will also be cleared for the members of the LAG in the Port RMON Statistics page.
5. Click Apply to apply the selected distribution scheme.