Cambium Networks PTP 820 Series, User Manual, Page: 216 / 1149

Chapter 3: Configuration Guide Configuring a Link Using the Quick Configuration Wizard
phn-3965_006v002
Page 3-58
2. In the Ethernet Interface field, select an Ethernet interface or a LAG for the group. Alternatively, click the
interface in the graphical representation of the unit. The selected interface is surrounded by a blue
square, as shown in
Figure 76 .
Note
To create a LAG, click Create LAG. The Create LAG Group page opens. For instructions on creating
LAG groups, see
Configuring Link Aggregation (LAG) and LACP .
3. In the Radio #1 Interface field, select the first radio interface for the group. Alternatively, click the
interface in the graphical representation of the unit. The selected interface is surrounded by a blue circle,
as shown in
Figure 76 .
Note
The Number of Radio Interfaces field is read-only.
4. In the Pipe Type field, select the Attached Interface type for the service that will connect the radio and
Ethernet interfaces. Options are:
o
s-tag - All S-VLANs and untagged frames are classified into the service.
o
dot1q - All C-VLANs and untagged frames are classified into the service.
Note
For a full explanation of Ethernet Services, service types, and attached interface types, see
Configuring Ethernet Service(s) .
5. Click Next . The Radio #2 Selection page opens.
Figure 78 N + 0 Multi Carrier ABC Quick Configuration Wizard – Radio #2 Selection Page – PTP 820G