Cambium Networks PTP 820 Series, User Manual

Page: 133 / 1149

Chapter 2: Getting Started Enabling the Interfaces (Interface Manager)
phn-3965_006v002
Page 2-38
Enabling the Interfaces (Interface Manager)
The following are the default settings for fixed interfaces on PTP 820G and PTP 820F unit's:
•
Ethernet traffic interfaces, the second management interface, and the Synchronization interface are disabled,
and must be manually enabled as described below.
•
Radio interfaces, the first management interface, and the TDM interface (optional) are automatically enabled.
•
PTP 820F supports both single-carrier and MultiCore RFUs. If the PTP 820F is connected to a single-carrier RFU,
the radio interface is displayed in the Web EMS as Radio Slot 1 Port 1. If the PTP 820F is connected to a
MultiCore RFU, the radio interfaces are displayed in the Web EMS as Radio Slot 1 Port 1 and Radio Slot 1 Port
2, where Port 1 represents the first radio carrier on the MultiCore RFU, and Port 2 represents the second radio
carrier on the MultiCore RFU. The MAC address of the MultiCore RFU is presented in the Port 1 row.
Note
Radio Slot 1 Port 2 always appears, even if the IDU is connected to a single-carrier RFU such as RFU-S.
If the PTP 820F is connected to a single-carrier RFU, or if the second carrier of a MultiCore RFU is not
in use, you should set the
Admin status field of Port 2 to Down to disable the radio interface and
prevent unnecessary alarms.
To enable and disable interfaces:
1 Select Platform > Management > Interface Manager . The Interface Manager page opens.
Figure 33 Interface Manager Page PTP 820F