Cambium Networks PTP 450 Series, Configuration Manual

Page: 261 / 649

Chapter 1: Configuration Monitoring the Link
Page
1-233
Monitoring the Link
Link monitoring procedure
After configuring the link, either an operator in the network office or the SM/BHS INSTALLER user in the
field (if read access to the AP/BHM is available to the INSTALLER) must perform the following
procedure. Who is authorized and able to do this depends on local operator password policy,
management VLAN setup and operational practices.
To monitor the link for performance, follow these instructions:
Procedure 14 Monitoring the AP-SM link
1 Access the web interface of the AP/BHM
2 In the left-side menu of the AP/BHM interface, select Home.
3 Click the Session Status tab.
Figure 32 Session Status page
4 The Device tab of Session Status List display all displayed SMs – MAC address, PMP/PTP
Hardware, Software Version, FPGA Version and State