Cambium Networks PMP 450, Configuration And User'S Manual, Page: 78 / 196

Task 4: Configuring General and Unit
settings Chapter 2: Configuration and alignment
2-46
pmp-0050 (May 2012)
Unit Settings Tab of the AP
Table 20 Unit Settings tab of the AP
The Unit Settings tab of the AP contains an option for how the AP should react when it detects a connected
override plug. You may set this option as follows.
Table 21 AP Unit Settings attributes
Attribute Meaning
Set to Factory Defaults
Upon Default Plug
Detection
If Enabled is checked, then an override/default plug functions as a
default plug. When the module is rebooted with the plug inserted, it
can be accessed at the IP address 169.254.1.1 and no password, and
all parameter values are reset to defaults. A subscriber, technician, or
other person who gains physical access to the module and uses an
override/default plug
cannot see or learn the settings that were
previously configured in it. When the module is later rebooted with
no plug inserted, the module uses the new values for any parameters
that were changed and the default values for any that were not.
If
Disabled is checked, then an override/default plug functions as an
override plug. When the module is rebooted with the plug inserted, it
can be accessed at the IP address 169.254.1.1 and no password, and
all previously configured parameter values remain and are displayed.
A subscriber, technician, or other person who gains physical access
to the module and uses an override/default plug
can see and learn the
settings. When the module is later rebooted with no plug inserted,
the module uses the new values for any parameters that were
changed and the previous values for any that were not.
See
Overriding Forgotten IP Addresses or Passwords on AP on Page
2-60 .