Hardware Overview
22
8. While looking for the far node through the site, rotate the fine azimuth adjuster until the alignment is
complete in the azimuth plane. One turn of the adjustment wheel is equivalent to approximately one
degree of azimuth. Lock the fine azimuth adjuster screws in place.
9. Make any remaining adjustments to the elevation and azimuth as required. Once complete, tighten
the three Nyloc screws in place to fix the elevation alignment and do the same for the two Nyloc
screws for azimuth alignment to 10 Nm (7.4 lbft) using a 13 mm spanner or socket.
V3000 tilt bracket assembly
1. Fix the mounting plate of the tilt bracket to the back of the radio using four of the short bolts,
ensuring that the arrow in the plate points towards the top of the radio. Tighten the four bolts to a
torque setting of 5.0 Nm (3.7 lb-ft) using a 13 mm spanner or socket.
2. Fit the two long bolts through the bracket body so that the bolt heads engage in the slots as
shown. Fit two of the short bolts into the side of the bracket body but do not tighten.