Calrec BRIO 36, User Manual

Page: 18 / 210

18 BRIO 36
Audio Production System with Optional Networking
PRODUCT INFORMATION
FIGURE 2 - IMPORTANT INFORMATION
Earthing
This is a Class I product. An Earth connection MUST be provided in each AC power cord.
The Earth Bolt connection at the rear of the console should be connected to Earth using Earth cable at least 6mm2
in cross section (10 AWG), this connection is optional and is NOT a requirement to comply with safety standards.
Lithium Battery Replacement
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Batteries must not be exposed to excessive heat such as sunshine, fire or the like.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Other Symbols in Use
For apparatus intended to be used at altitude not exceeding 2000m, a warning label containing the following symbol
shown in Figure 3, shall fixed to the equipment at readily visible place.
FIGURE 3 - ALTITUDE WARNING SYMBOL
Lifting and Carrying Brio 36
Brio has two lifting handles on the rear of the unit. These should be used when lifting the unit into place. Note: this unit
weighs approximately 30kG and requires at least 2 persons to lift or carry the unit.
Levelling or Fixing Brio 36 on a surface for table mount.
Brio has four adjustable feet on its base which can be used to level the console on a surface. Alternatively these can be
removed and four M6 screws fitted to fix the console in place. Note: the screws should not screw in further than 20mm into
the body of the unit.