![background image](http://html1.mh-extra.com/html/calpeda/unimat-e-series/unimat-e-series_installation-operation-and-maintenance-instructions-manual_4127106017.webp)
- 17 -
Cont ...
The unit is fitted with an internal re-settable fuse, see Section 11.
5.26
Supply cord replacement:
The supply cord and internal wiring within the terminal
box are routed and secured to ensure compliance with the
electrical standard EN 60335-1. It is essential that prior to
any disturbance of this internal wiring, all cable routing and
securing details are carefully noted to ensure re-assembly to
the same factory pattern is always maintained.
If the supply cord is to be changed or is damaged, it must be replaced with a
special cord assembly available from Calpeda Ltd or one of their approved
repairers.
On disassembly note the cord retention and routing system. Re-assemble to
the same pattern.
For information on cable connection consult the wiring diagram.
4) Re-insert connector into the correct location on the control board and route
the cable to the back of the unit and secure with a cable tie to the retainer.
Model
Fuse Size (AMPS)
All models
5
5.24
RS 485 Modbus – BMS Connection:
RS 485 is available on this product for BMS connection and is enabled in the
Advanced settings menu.
5.25
Fuses:
The following fuse size should be used:
Fig. 19
Retainer
Cable tie
Summary of Contents for Unimat-E Series
Page 35: ...35 Cont NOTES...