![background image](http://html1.mh-extra.com/html/california-instruments/2001rp/2001rp_user-and-programming-manual_3444999092.webp)
User and Programming Manual - Rev N
10.2 Calibration Subsystem
The commands in this subsystem allow you to do the following:
•
Enable and disable the calibration mode
•
Calibrate all measurement circuits and store new calibration coefficients in nonvolatile
memory.
Subsystem Syntax
CALibrate
:STATe
Enables
or
disables
the
calibration
mode
:MEASure
:CURRent
[:FSC]
Calibrate
full
scale
AC
current
measurement
:ZERO
Trim
AC
current
measurement
offset
:PCURrent
[:FSC]
Calibrate
full
scale
AC
peak
current
measurement
:ZERO
Trim
AC
peak current measurement offset
:POWer
[:FSC]
Calibrate
full
scale
AC
power
measurement
:ZERO
Trim AC power measurement offset
:VOLTage
[:FSC]
Calibrate
full
scale
AC
voltage
measurement
:ZERO
Trim
AC
voltage
measurement
offset
[:SOURce]
:VOLTage
Calibrate
output
voltage
10.2.1 Calibration State
CALibrate:STATe
This command puts the AC source in calibration mode. The calibration mode is required to
use the data entry form of the calibration commands. Without setting the correct state using
this command, only the query form can be used to query any calibration coefficients but no
new calibration can be performed. Calibration queries return the calibration coefficient for
the specified measurement parameter. Calibration coefficients range from -127 to + 127.
Note
Any changes made to calibration coefficients are not saved in non-volatile
memory until the SYSTem:SAVE command is issued before turning the Cal
state off.
CAL:STAT 0
Turns calibration mode off.
CAL:STAT 1
Turns calibration mode on.
Command Syntax
CALibrate:STATe 0|1
Parameters <Bool>
Examples
CAL:STAT 1
CAL:STAT 0
Related Commands
CAL[:SOUR]
CAL:MEAS
SYST:SAVE
2001RP April
2007
83
Summary of Contents for 2001RP
