Decimator Quick Tour
SED Systems, a division of Calian Ltd.
(Proprietary)
23
9.
Save and Restore
Now that you have done all this work, it is a good idea to save the configuration to a project XML
file locally on disk. This saves your settings, markers, memory traces, states, and measurements.
Note, that the saving does not save the data on the Decimator card, but to a local file. Use this
project file to recall your configuration in the case of a power outage or send it to a colleague with
the same set of carriers at a different location. Click the SAVE/OPEN button then the Save Project
menu item. Enter a file name and click Save.
Figure 28 Save a Project
Close the Decimator UI to allow us to start over from scratch. Open a new Decimator UI session by
entering the IP Address in the browser. Click the SAVE/OPEN button and click the Open Project
menu item. Browse to the project file just saved and click Open.
Figure 29 Open a Project
The previous Decimator configuration is restored, including the Carrier Monitoring measurements.
Total Elapsed Time: 36 minutes
