CAL
-SERIES
39
ALTERNATIVELY, for models CAL-40A (ALL) CAL-50A (ALL) and CAL-75A (ALL) installer can use material
equal to Cal
cana 3” x 16 gauge sidewall vent kit PIN#800208, c/w 4” x 3” 16 gauge reducer.
NOTE: MAKE SURE THAT ALL FLUE/EXHAUST JOINTS ARE SEALED. USE ONLY SUITABLE PRODUCTS EQUAL TO GENERAL ELECTRIC
RTU 106 OR PERMATEX FORM A GASKET RED HIGH TEMPERATURE SILICONE ADHESIVE SEALANT. (NOT SUPPLIED)
D
NOTE: VENT PIPE CAN BE TRIMMED IF NEEDED. CUT EXCESS MATERIAL AS REQUIRED. MAINTAIN 6” (16 cm) CLEARANCE TO
COMBUSTIBLES. SEAL ALL JOINTS WITH HIGH TEMPERATURE SILICON (SEE PAGE 36).
Figure 32. SIDE WALL VENTING, SINGLE UNIT
NOTE: Maximum length is 25 feet including, two (2) 90° elbows,
deduct 10’ for every additional 90° elbow
and 5’ for every 45° elbow.
