10/12/13
LMU-3000 Hardware & Installation Guide - PULS Wiki
https://puls.calamp.com/wiki/LMU-3000_Hardware_%26_Installation_Guide
19/33
AT$APP MODEM UPDATE
This command is also used to initiate an Over-The-Air PRL Update for devices that are already provisioned.
Users may also force a reactivation with the command:
AT$APP MODEM ACTIVATE
Keep in mind, however, this may cause the modem to lose its credentials and become unable to register to the
network.
4.5.2 Activating a CDMA LMU-3000™ – Sprint
Activating an LMU-3000™ on the Sprint CDMA network is identical to activating on the Verizon network.
1. Power on the LMU-3000™, making sure you can observe the behavior of the Comm LED.
2. Wait until the Comm LED turns solid. This could take up to 5 minutes.
3. If after 5 minutes you observe that the Comm LED transitions from a slow blink to a fast blink
several times (i.e. more than twice) you will need to contact Sprint for further support on account
activation..
Once configured, you may verify that the LMU-3000’s™ modem has registered to the CDMA network.
Enter:
AT$APP COMM STATUS?
The response should be similar to:
CDMA Service:
IS-2000
Connection:
Yes
RSSI:
-80 dBm
Channel:
0
Band:Side:
800:B
Base Station ID: 0
Network ID:
0
System ID:
4145
ESN (Modem S/N: 2676319948 [9F8566CC]
Phone Number:
1234567890
IMSI:
310001234567890
CarrierConfig:
1
The Phone Number field should match the <Phone Number> value you used in step 3 or 4. The last 10 digits
of the IMSI field should match the <MSID> value you used in step 3 or 4.