CAL PUMP LIMITED WARRANTY
Every Cal Product is tested before shipment and when properly used and maintained
will provide years of satisfaction. In the unlikely event that our material or
workmanship should prove defective within the warranty period, return the pump
along with proof of purchase to the original dealer for inspection and replacement if
needed. If you prefer, the product may be returned directly to Cal Pump for repair or
replacement. Be sure to include your name, address, proof of purchase, and reason
for return. All pumps must be returned freight prepaid. Warranty does not cover any
costs associated with the installation or removal of products subject to warranty
claims. This limited warranty is extended only to the original purchaser and is void if
any of the following apply:
1.
The pump has been dissembled.
2.
Alterations have been made to the cord or plug.
3.
The pump has been run dry.
4.
Flammable liquids, solvents, chemicals, or abrasive solutions were pumped.
5.
Obvious abuse or misuse of the product took place.
All implied warranties including the implied warranty of merchantability are limited
in duration to the same extent as the express warranty as allowed by the state law. Cal
Pump expressly disclaims and excludes any liability for consequential or incidental
damages for breach of any express or implied warranty, as allowed by the state law.
WARRANTY PERIOD
One Year from date of purchase.
DEALERS/DISTRIBUTORS
You are authorized by Cal Pump to make a warranty determination on our behalf.
Please exercise your own good judgment in accordance with the provisions of the Cal
Pump warranty listed above.
For credit or replacement, return the product to Cal Pump, freight prepaid.
RETURN PRODUCT TO:
Cal Pump
28606 W. Livingston Ave Valencia, CA 91355
Attn: Service Department
P/N 13751 REV (02/05)
28606 W. LIVINGSTON AVE • VALENCIA, CALIFORNIA 91355
TORPEDO PUMP
General instructions
Introduction/ Overview
Congratulations on your purchase of the Cal Pump ‘Torpedo Pump’.
To ensure efficient and faultless operation, it is, however, important to read carefully
and strictly comply with this service manual.
Safety Measures
Caution: Before assembly and startup, carefully read this service manual.
For safety purposes do not use the pump until you have read the instructions.
ELECTRICAL SUPPLY
Before connecting the pump to the power source,
verify that the power source is of
the same voltage and frequency listed on the pump.
The National Electric Code
and most local codes
REQUIRE
that a ground fault circuit interrupter (GFCI) be
installed in the branch circuit feeding your pump. For your own safety we urge you
to comply with this regulation. Extension cords or splices should
NEVER
be used
with submersible pumps. The Power Control Center (PC50) can be used with the
T1500 and the T4000 and is available through your dealer.
