•
first line: display the location of parameter.
•
sencond line: display the value of parameter. these parameters are
different under different mode. The above example takes CC priority as
example.
2. Rotate the knob and enter the number 1 to 10 and set the recall location,
press
[Enter]
to recall the parameters.
7.3 Local/Remote Mode Switch
The instrument provides both local and remote operation modes. The default
mode is local operation mode.
•
Local operation mode: Use the front panel keys to control the power system.
•
Remote operation mode: The power system is connected to PC, and the
user uses the software in PC to control the power system remotely. During
remote control operation, the remote symbol “Rmt” is displayed. All panel
keys, except for the
[On/Off]
and
[Shift]+[Link]
(Local) keys are locked.You
can press
[Shift]+[Link]
(Local) to switch the remote control to local control.
The mode modification will not affect the output parameters of the power
system.
7.4 Basic Operation
This chapter describes the basic functions and features of the instrument. Div-
ided into the following sections:
7.4.1 Set the Beeper Status
The user can turn the instrument beeper sound on or off according to personal
requirement.
•
On status: A beeper sound produced when the front panel key is pressed.
Default status is on.
•
Off status: The beeper is disabled.
Operation procedures:
1. Press the composite keys
[Shift]+[P-Set]
(System) to enter the System
menu interface.
2. Rotate the knob to select
Beep
and press
[Enter]
to confirm.
3. Rotate the knob to select
On
or
Off
and press
[Enter]
to confirm.
4. Press
[Esc]
to exit menu interface.
At this point, the beeper status takes effect immediately.
Copyright © Itech Electronic Co., Ltd.
75
