LMU-2x20™ Hardware and Installation Guide
V1.0.10
December 12, 2010
Copyright ©Calamp Wireless Networks Inc 2010
- 24 -
CalAmp Proprietary & Confidential
3.6
Quick Start - General Config
All LMU-2x30s™ must go through a common step during the configuration and
provisioning process. Specifically, this is pointing the LMU to the LM Direct™ server, either
via IP or a URL
This configuration process is accomplished via a series of AT Commands.
1.
Power up the LMU-2x30™
2.
Plug the serial cable into your laptop
3.
Open a terminal session to the LMU-2x30™
4.
Enter the address of the LM Direct™ server.
AT$APP PARAM 768,0,ddd.ddd.ddd.ddd
AT$APP PARAM 769,0,ppppp
where ddd.ddd.ddd.ddd is the publicly addressable IPV4 address of the server and
ppppp is the UDP port number
The LMU-2x30™ will respond with: OK
5.
Alternatively if a URL has been set up it may be programmed with:
AT$APP PARAM 2319,0, “myURL.MyCompany.Com”
Where “myURL.MyCompany.com” is the URL assigned to the server, the LMU-
2x30™ will respond with: OK
Note that if you are not using a URL, this field must be cleared using:
AT$APP PARAM 2319,0, “”
6.
Verify your settings by using:
AT$APP INBOUND?
