CAKEWALK UM-3G, Owner'S Manual, Page: 39 / 52

39
Appendices
If you’re using several connected UM-3G (or UM-3EX) units, proceed as follows to install the
driver and connect the units.
Windows Vista users
1.
First, carry out the installation for only the first UM-3G unit, as described in “Installing
the Driver” (p. 12).
When installation is completed, temporarily disconnect the UM-3G from the computer.
* Do not connect the second or third UM-3G (or UM-3EX) units at this point.
2.
If you’re also using an UM-3EX, install the UM-3EX driver using the same procedure as
in step 1.
The UM-3EX driver is provided on the included “UM-2G/UM-3G CD-ROM.”
Support\UM-3EX Driver\Vista\Setup.exe
3.
Set the [MODE] switch and [UNIT] switch of the UM-3G (or UM-3EX).
* Even if you’re using the UM-3G in combination with a UM-3EX, you must use the UM-3G as the
first unit connected to the computer. You can’t use the UM-3EX as the first unit.
4.
Connect the second UM-3G (or UM-3EX) to the upper of the first UM-3G unit’s two
UM-3G/UM-3EX connectors.
5. Connect the third UM-3G (or UM-3EX) to the lower of the first UM-3G unit’s two UM-
3G/UM-3EX connectors.
6.
Connect the first UM-3G unit to the computer.
Preparations to use the devices will start automatically.
This completes driver installation.
Installing the Driver
[MODE] switch [UNIT] switch
First UM-3G unit MASTER 1
Second UM-3G (or UM-3EX) unit SLAVE 2
Third UM-3G (or UM-3EX) unit SLAVE 3
UM-3G_e.book 39 ページ ２００８年１１月２０日 木曜日 午後４時１０分