CAKEWALK UM-2G, Owner'S Manual, Page: 19 / 44

19
Getting Connected and Installing Drivers
8.
The screen will indicate “Installing this software requires you to restart your
computer when the installation is done.”
Click [Continue Installation] .
9.
The screen will indicate “Click Restart to finish installing the software.”
Click [Restart] to restart your Macintosh.
* It may take some time for your Macintosh to restart.
This completes installation of the UM-2G driver.
Next, make MIDI device settings.
* You won’t be able to use the UM-2G unless you’ve made these settings.
1.
Set the UM-2G’s [ADVANCED DRIVER] switch to the ON position.
2.
Connect the UM-2G to your Macintosh.
3.
Open the Applications folder of your Macintosh hard disk. In the Utilities folder,
double-click [Audio MIDI Setup] to open the Audio MIDI Setup dialog box.
The Audio MIDI Setup dialog box will appear.
4. Click the MIDI Devices tab.
5.
Confirm that UM-2G appears in the Audio MIDI Setup dialog box.
* If UM-2G does not appear or if it is grayed out, it means that the UM-2G
is not being recognized properly. Click [Rescan MIDI] . Also try
disconnecting and reconnecting the UM-2G.
* Previous settings from installation of a different version of the driver may
still remain. If this is the case, click on the grayed UM-2G to select it, then
click [Remove Device] to delete the settings.
MIDI Device Settings
Operation of the UM-2G
Operation of the UM-2G
4
7
6
Click MIDI Devices
Click Add Device
Click Show Info
UM-2G_e.book 19 ページ ２００８年１１月１２日 水曜日 午後１０時６分