Replacing a fork suspension
Tool: Allen key 5mm, 8mm, 10mm, Torx 30.
1. Place the vehicle on a stand or similar.
2. Loosen the screw clamping the wheel axle. Use Allen key 6mm.
3. Remove the wheel by unscrewing the front wheel axle. Use Allen key 8mm
and 10mm.
4. Unscrew the 6 screws behind the front fender. Use Torx 30.
5. Unscrew the 6 top screws. Use Allen key 5mm. Remove the fork suspension.
6. Mount the new fork suspension. Tighten the 6 screws to 10Nm.
7. Mount the wheel. Tighten the wheel axle screw to 50Nm. Use Allen key
8mm and 10mm.
8. Tighten the screw clamping the wheel axle to 17 Nm. Use Allen key 6mm.
9. Perform a test drive to check the brake system.
Fastening the rear suspension
1. Check that there is no gap between the rear suspension spring (B) and the
adjustment ring (A).
2. If necessary, tighten the adjustment ring.
3. Tighten the stop screw of the adjustment ring.
42
Fig. 22
Rear suspension spring and adjustment ring
A
B
Summary of Contents for Makka
Page 1: ...Makka Manual Makka Manual...
Page 62: ......
