Stor-Dry™ Model 9406
*
SAVE THESE INSTRUCTIONS
*
The Stor-Dry Warm Air Circulator combats mold and mildew by reducing the amount of
moisture available for spores to grow and multiply. This is accomplished using a unique
dual action that utilizes both a low wattage heating element and a fan to circulate air.
Operating Instructions
Simply plug the unit into the appropriate outlet. Red LED indicates when unit is
operating. Make sure that airf
l
ow is not restricted. The heater has been designed
for continuous operation. Current draw is less than a 100 watt light bulb.
NOTE: The key to keeping any area free of moisture is proper ventilation.
CAUTION! Surface is hot, avoid contact.
WARNING:
This unit is equipped with a thermal protection device. Should the unit be
covered in clothing or other material it may overheat and shut down. In the
event of the unit overheating and shutting down, it will remain off until it is
reset. To reset, unplug the unit and ensure that it is not covered by anything.
Let the unit cool for ten minutes before plugging it back in.
Specif
i
cations
120 Volts, 60Hz, 0.6A, 7
0
Watts
230 Volts, 50Hz, 0.
3
3A, 7
0
Watts
Care and Maintenance
The Stor-Dry
™
requires very little maintenance. By following the instructions within
this manual the heater will operate problem-free for years.
Unplug unit before cleaning.
A vacuum can be used to clear the heater of any dust
build-up and a dry cloth may be used to wipe the outer surface.
Do not attempt to open the unit to clean.
Operation
An internal blower pulls cool, damp air in the bottom and releases
warm dry air through the top. Active air circulation
technology raises the ambient temperature above the dew
point to control mold and mildew. Designed for low cost
continuous use.
The amount of water vapour air can hold
(absolute humidity) increases with temperature. The
Stor-Dry
™
low wattage heating element slightly warms the
room’s air to keep the moisture suspended rather than
condensing on surfaces where mold spores can use it to
grow.
Secondly, the Stor-Dry
™
fan keeps a small amount of
air moving throughout the room to help prevent any moisture
from condensing on surfaces to again impede the growth of
mold spores.
